PROEL MS 32 - Set Mode; Set Selection (0~9)

16
Proel MS 32 Owner's Manual
SET MODE
In the SET mode it is possible to:
- recall the 10 SETS stored in the pedalboard using the switches from 0 to 9
- recall the 10 SETS stored in the pedalboard using the switches "  "
- activate START/STOP and CONTINUE functions
- edit the SET parameters using the SELECT/CHANNEL" switch
SET SELECTION (0~9):
The pedalboard is in the SET mode when the SET LED is on, the cursor is under the SET Number
and the arrow points the SET Number.
When pressing one of the switches from 0 to 9 or one of the switches "  ", the left side of the
display shows the SET number recalled and the 10 characters name associated to it.
All the set parameters are recalled :
- Song from 0 to 127/Off (midi message F3 00~7F)
- “A” part Midi Channel setting (from 1 to 16)
- “B” part Midi Channel setting (from 1 to 16)
- the stored PATCH of the new recalled SET is automatically selected
- all the recalled Set and Patch parameters are transmitted via Midi
Example:
press the switch no. 6 once or the "  " switch six times, the display will show:
Note: The pedalboard allows you to recall alternatively two different sets using only one switch;
to recall alternatively the sets no. 3 and 7 press:
- the switch no. 3
- the switch no. 7
The pedalboard will now recall alternatively the sets no. 3 and 7 by pressing only switch
no 7.
6<*FACTORY6* 0
SET Number
SET Name
PATCH Number
EDIT SET SELECTION (0~9) START/STOP
CONTINUE