PROEL MS 32 - Start;Stop and Continue Functions; Note

Proel MS 32 Owner's Manual
17
START/STOP AND CONTINUE FUNCTIONS:
When the switch START/STOP is pressed once, the START "FA" Midi message is sent to a
computer or a module sequencer connected via Midi to start a song; the display will show an "s".
If the switch START/STOP is pressed again, the STOP "FC" Midi message is sent to the equipment
connected to stop the song and the "s" is no longer displayed.
Pressing the "CONTINUE" switch while the pedalboard is in its "STOP" condition, the
CONTINUE "FB" Midi message is sent to play again the song from the previous stop position; the
display shows once again an "s".
Note: The CONTINUE function is linked to the Global "Continue switch assign" parameter.
To operate as CONTINUE control, the "Continue switch assign" parameter must be
set in CNT or in PBS+CNT (cfr. page 11)
The CONTINUE switch can also operate only as PATCH BAY (PBS) selector if the
Global "Continue switch assign" parameter is set in PBS.
The "s" symbol is no longer displayed when the CONTINUE switch is kept pressed.
(cfr. page 33/34)
NOTE:
Remember to set in LOCAL (INTERNAL CLOCK, REMOTE CONTROL, etc.) all the
equipments (computer, module sequencer, etc.) connected via Midi to the MS 32 if you want to
control the START/STOP/CONTINUE functions from the pedalboard (note that no MIDI
CLOCK signal is sent via midi from the MS-32
).
0<*FACTORY0* s 0
START or CONTINUE selected