To Next Page

To Previous Page

1 Supplementary operating instructions for CANopen

1.1 About this pump............................................................ 4

1.2 Control elements........................................................... 5

1.3 Electrical installation..................................................... 5

1.4 Emergency mode.......................................................... 7

1.5 Troubleshooting............................................................ 7

1.6 Accessories.................................................................. 8

1.7 Appendix....................................................................... 9

1.7.1 Communication Profile Area 0x1000-0x1FFF............ 9

1.7.2 Manufacturer Specific Profile Area

0x2000-0x5FFF.........................................................

1.7.3 Device Profile Area 0x6000-0x9FFF........................ 16

1.7.4 Alarm Action Area for Measurement Devices

(404 )....................................................................... 19

1.7.5 EMERGENCY.......................................................... 19

1.7.6 Explanations of objects............................................ 21

1.7.7 Changing the CANopen node address (Node ID)... 24

1.7.8 Transfer rate (baud rate).......................................... 24

1.7.9 Calibration, explanations......................................... 24

1.7.10 Firmware update.................................................... 25

1.7.11 Data storage.......................................................... 25

1.7.12 Directives / standards complied with..................... 25

1.1 About this pump

Metering pumps DULCO flex Control DFXa with CAN connector

differ from standard pumps in that they can be connected to a

CANopen bus system. A CAN pump DULCO flex Control DFXa

can be connected to a CANopen bus or used as a standalone unit.

Example:

n Measurement value-dependent metering of sodium-calcium

hypochlorite into a swimming pool water circuit, in

‘CANopen’

operating mode, the pump being controlled by a controller.

A "CANopen" version of DULCO flex Control DFXa (Identity code

feature "Control type" = C or D) is designed for incorporation in a

CANopen system.

Supplementary operating instructions for CANopen

ProMinent DULCO flex Control Supplementary Operating Instructions

Other manuals for ProMinent DULCO flex Control