Promise Technology Apollo Cloud 2 Duo User Manual

Transferring Content from a USB Storage Device!
To save data on a USB storage drive to the Apollo, you can use the Apollo Utility or the Apollo
App. The USB Transfer procedure is described in this section, first using the Apollo Utility,
followed by instructions for the Apollo App. USB Transfer is a simple operation, just connect a
USB device, and instruct Apollo to proceed. However, you need to make sure there is enough
available storage capacity on Apollo to accommodate the transfer. Also, note that if you are a
large quantity of data, the transfer time will increase proportional to the amount of data being
transferred.!
USB Transfer with Apollo App!
To begin a USB Transfer to Apollo, attach a USB storage device to the USB port on Apollo, and
use the Apollo App to perform the steps below. !
1. Click the Settings icon and select the USB Transfer option. !
2. If the USB device is connected and ready for use, you will see the Start in blue text. If you
see a message telling you to a USB device is not connected, check the USB connection. It
might take a few minutes to recognize the device. If it is connected, the device might not
be suitable for with Apollo. !
&
51
Note!
Apollo requires the USB drive to use one of the following
file systems: exFAT, NTFS, HFS, EXT3 or EXT4.
Select USB Transfer in
Settings menu
Touch Start to proceed

Promise Technology Apollo Cloud 2 Duo Specifications

General

Storage media	HDD
Internal memory	1024 MB
Processor frequency	1000 MHz
Built-in storage media	Yes
Internal storage capacity	8 TB
Mobile operating systems supported	iOS
Number of storage drives installed	2
Product color	White
LED indicators	Power
AC adapter frequency	50/60 Hz
AC adapter input voltage	100 - 240 V
USB 2.0 ports quantity	0
Ethernet LAN data rates	1000 Mbit/s
USB data transfer rates	5000 Mbit/s
USB 3.2 Gen 1 (3.1 Gen 1) Type-A ports quantity	1
Cables included	LAN (RJ-45)

Weight and Dimensions

Depth	213.3 mm
Width	123.23 mm
Height	137.41 mm
Weight	2300 g