SmartStor NS2300N Product Manual
92
5. Enter the Domain name into the field provided.
See your Network Administrator for help with this information.
6. Click the OK button to save your settings.
7. In the Tree, click the + beside the File Sharing icon.
8. Click the Modify tab.
9. From the Folder name dropdown menu, choose the folder you want to
access.
10. Check the UNIX/Linux box.
11. Click the OK button to save your settings.
12. In the Tree, click the + beside the Sharing Setup icon.
13. Click the UNIX/Linux Sharing tab.
14. Choose a folder from the Folder Name dropdown menu.
15. In the New IP Address field, type the IP address of the UNIX or Linux PC
from which you will access this folder, then click the Add button.
You must designate the IP addresses for each folder individually. You can
have up to 256 IP addresses for all of your folders.
16. Click the OK button to save your settings.
You can now access the folder you chose from a UNIX or Linux PC.
See “Chapter 3: Connecting to the SmartStor” on page 21 for information
about the settings that you must make on your PC.
Setting up for Macintosh Access
To set up access from a Macintosh PC:
1. In the Tree, click the + beside the File & Print icon to expand the Tree, then
click the Protocol Control icon.
2. In the Information tab, click the Enable button next to Macintosh.
3. Click the OK button in the confirmation box.
4. In the Tree, click the + beside the File Sharing icon.
5. Click the Modify tab.
6. From the Folder name dropdown menu, choose the folder you want to
access.
7. Check the Macintosh box.
8. Click the OK button to save your settings.
You can now access the specified folder from a Macintosh PC.
See “Chapter 3: Connecting to the SmartStor” on page 21 for information
about the settings that you must make on your PC.
To Next Page
Loading...
Need help?
General
