Need help?Do you have a question about the Promise Technology Vess A3340 and is the answer not in the manual?
General| Supported RAID Levels | 0, 1, 5, 6, 10, 50, 60 |
|---|---|
| Expansion Slots | 1 x PCIe 3.0 x8 |
| Memory | 16GB DDR4 ECC |
| Power Supply | Redundant 550W |
| Interface | SATA/SAS |
| Max Devices Supported | 16 drives |
| Cache Memory | Up to 8GB per controller |
| Host Bus Speed | 12Gb/s SAS |
| Ports | 2 x USB 3.0 |
| Operating System Support | Windows, Linux |
| Form Factor | 2U Rackmount |
| Network Ports | 2 |
Lists the technical specifications of the Vess A3340 NVR Storage Appliance.
Describes the backplane of the Vess A-Series enclosure and its ports.
Provides instructions for installing the Vess A3340 unit into a standard 19-inch rack.
Information on required drives per RAID level and installing disk drives.
Step-by-step guide to open the Command Line Interface in Windows.
Instructions for logging into and navigating the Command Line Utility interface.
Covers subsystem, controller, enclosure, and drive management using CLU.
How to configure global settings for physical drives, like cache and DMA modes.
Explains the automatic, express, and advanced methods for creating disk arrays.
Steps to create a new logical drive on an existing disk array with specified parameters.
Procedures for logging into the WebPAM PROe interface via enclosure or network.
How to manage subsystems, including background activities, event logs, and administrative tools.
To Next Page