Making Controller Settings (CLU)
If your subsystem has two controllers, any settings you make to one controller automatically apply
to the other controller.
To make Controller settings:
1. Main Menu >> Subsystem Management >> Controller Management
2. Highlight the controller you want and press Enter.
3. Highlight Controller Settings and press Enter.
4. Make the following settings as required:
• Type an alias into the Alias eld.
Maximum of 48 characters. Use letters, numbers, space between words and un-
derscore. An alias is optional.
• Highlight Coercion and press the spacebar to toggle
between Enabled and Disabled.
For more information, see “Capacity Coercion”.
• Highlight Coercion Method and press the spacebar to toggle through:
GB Truncate – Reduces the capacity to the nearest 1 GB boundary.
10 GB Truncate – Reduces the capacity to the nearest 10 GB boundary.
Grp (group) Rounding – Uses an algorithm to determine truncation. Results in the
maximum amount of usable drive capacity.
Table Rounding – Applies a predened table to determine truncation.
38
Vess A Class NVR Storage Appliance Promise Technology
To Next Page
Loading...