Web Server Settings (CLU)
By default, Web Server service is set to Automatic and its normal status is Started.
To make Web Server service settings:
1. Main Menu >> Additional Info and Management >> Software Management >>
Startup Type
2. Press the spacebar to toggle between Automatic and Manual.
3. Highlight the following and press the backspace key to erase the current value, then type the
new value:
• HTTP Port (8090 is the default)
• Session Time Out (24 minutes is the default. 1440 minutes = 24 hours)
4. Highlight SSL and press the spacebar to toggle between Enabled and Disabled.
5. Highlight HTTPS Port and press the backspace key to erase the current value, then type the
new value. 8443 is the default.
6. Press Control-A to save your settings.
To start, stop or restart the service, highlight Start, Stop, or Restart and press Enter.
84
Vess A Class NVR Storage Appliance Promise Technology
To Next Page
Loading...
Need help?
General
