SNMP Settings (CLU)
By default, Simple Network Management Protocol (SNMP) service is set to Automatic and its normal
status is Started.
To make SNMP service settings:
1. Main Menu >> Additional Info and Management >> Software Management >> SNMP
>> Startup Type
2. Press the spacebar to toggle between Automatic and Manual.
3. Highlight the following and press the backspace key to erase the current value, then type the
new value:
• Port Number – 161 is the default
• System Name – (optional) Type a system name in this eld
• System Location – Type a country name in this eld
• System Contact – Type the email address of your system administrator in this eld
• Read Community – Type a community name in this eld
4. Press Control-A to save your settings.
To start, stop or restart the SNMP service, highlight Start, Stop, or Restart and press Enter.
85
Managing with CLUVess A3340 Product Manual
To Next Page
Loading...
Need help?
General
