5. Highlight the following parameters and press the spacebar to toggle though the available
choices:
• Stripe size – Press the spacebar to choose: 64 KB,
128 KB, 256 KB, 512 KB, or 1 MB.
• Sector size – Press the spacebar to choose: 512 B; 1 KB, 2 KB, or 4 KB.
• Write Policy – Press spacebar to choose: Write Back or Write Through.
• Read Policy – Press spacebar to choose: No Cache,
Read Cache, or Read Ahead Cache.
6. RAID 30, 50 and 60 only. Highlight Number of Axles and press the spacebar to choose the
number of axles.
7. Highlight Save Logical Drive and press Enter.
Note
If you did not use all of the available capacity of the disk array, you can
create an additional logical drive at this point.
67
Managing with CLUVess A3340 Product Manual
To Next Page
Loading...