Chapter 4: SmartNAVI
67
Making Management Settings
This category includes the following topics:
• Configuring a NAS System (page 67)
• Changing Network Settings (page 69)
• Locating the SmartStor (page 70)
• Choosing a Default NAS System (page 70)
• Enabling or Disabling Event Notification (page 70)
• Viewing the System Event Log (page 71)
• Adding Plug-ins (page 71)
• Viewing a List of Plug-ins (page 72)
• Viewing Plug-in Version Numbers (page 72)
• Enabling and Disabling Plug-ins (page 73)
• Removing Plug-ins (page 73)
Configuring a NAS System
The Setup Wizard has two modes:
• One Click Setup – Loads a collection of default settings. Recommended for
most users.
• Advanced Setup – Enables you to make your own settings. Recommended
for advanced users.
One Click Setup
To configure your NAS system using One Click Setup:
1. Go to the Main Window.
2. Click the Setup Wizard icon.
3. Click the One Click Setup button.
4. Click the OK button.
Advanced Setup
To configure your NAS system using Advanced Setup:
1. Go to the Main Window.
2. Click the Setup Wizard icon.
Caution
Do NOT run the Setup Wizard on a NAS system that is already
configured! That action will delete your data and network drives!
To Next Page
Loading...
Need help?
General
