SmartStor NS2300N Product Manual
108
Making Management Settings
This category includes the following topics:
• Viewing the Event Log (page 108)
• Setting up SMTP Authentication (page 108)
• Viewing the Email Alert List (page 109)
• Adding an Email Alert Recipient (page 109)
• Deleting an Email Alert Recipient (page 109)
• Upgrading the System Firmware (page 110)
• Enabling and Disabling the Buzzer (page 110)
• Viewing UPS Status (page 110)
• Setting up a UPS (page 111)
Viewing the Event Log
The event log keeps a log of the 20 most recent events on the SmartStor. You
can use this information to review your actions and to diagnose problems.
To view the Event Log:
1. In the Tree, click the + beside the Management icon.
2. Click the Event Log icon.
A list of the 20 most recent events displays on the Event Log tab.
Events are ranked in severity as Information, Warning, and Error.
Setting up SMTP Authentication
In order to set up email alerts over a network, you must enable the SMTP
service, specify a SMTP server, and in most cases, supply authentication
information. See your Network Administrator for help with these settings.
To set up SMTP authentication:
1. In the Tree, click the + beside the Management icon.
2. Click the Mail Alert icon.
3. Click the Setup tab.
4. Next to Service, click the Enable option button.
5. In the SMTP Server field, type the IP address or the DNS name of your
SMTP server.
6. In the From field, the sender’s email address that you want to appear in the
alert messages.
To Next Page
Loading...
Need help?
General
