Promise Technology SmartStor NS2300N - Checking the Event Log in PASM

SmartStor NS2300N Product Manual
128
4. Click the Rebuild File System button.
5. In the confirmation box, type yes into the field provided, then click the OK
button.
Checking the Event Log in PASM
To view the Event Log in PASM:
To check Enclosure status:
1. Start PASM.
See “PASM in your Browser” on page 80.
Or see “PASM in SmartNAVI” on page 81.
2. In the Tree, click the + beside the Management icon.
3. Click the Event Log icon.
The Event Log displays. See Figure 4.
Figure 4. The PASM Event Log
4. Check the Event Log for reports of disk drive failure or other problems.