protech PA-6225 User Manual

Chapter 3 Software
PA-6225 SERIES USER MANUAL
Page 156
BIOS Setup
Menu Key
Description
<←> and <→>
Selects a different menu screen (move the cursor from
the selected menu to the left or right).
<↑> and <↓>
Selects a different item (move the cursor from the
selected item upwards or downwards)
Enter
Executes the command or select the sub-menu.
<F2>
Loads the previous configuration values.
<F3>
Loads the default configuration values.
<F4>
Saves the current values and exit the BIOS setup menu.
<Esc>
Closes the sub-menu.
Trigger the confirmation to exit BIOS setup menu.
BIOS Messages
This section describes the alert messages generated by the board’s BIOS. These
messages would be shown on the monitor when certain recoverable errors/events
occur during the POST stage. The table bellow gives an explanation of the BIOS alert
messages:
BIOS Message
Explanation
A first boot or NVRAM
reset condition has been
detected.
BIOS has been updated or the battery was replaced.
The CMOS defaults
were loaded.
Default values have been loaded after the BIOS was
updated or the battery was replaced.
The CMOS battery is
bad or has been recently
replaced.
The battery may be losing power and users should
replace the battery immediately. Also, this message is
displayed once the new battery is replaced.

protech PA-6225 Specifications

General

Brand	protech
Model	PA-6225
Category	Touch terminals
Language	English