3-1-3. VGA Driver Utility
The VGA interface embedded with PA-6225 can support a wide range of display
types. You can have dual displays by configuring CRT & LVDS interfaces to work
simultaneously.
3-1-3-1. Installing VGA Driver
To install the VGA driver, follow the steps below:
1. Connect the USB-DVD ROM device to PA-6225 and insert the driver disk.
2. Open the “VGA” folder where the VGA driver is located (depending on your
OS platform).
3. Click Setup.exe file for driver installation.
4. Follow the on-screen instructions to complete the installation.
5. Once the installation is completed, shut down the system and restart PA-6225
for the changes to take effect.
3-1-4. LAN Driver Utility
PA-6225 is enhanced with LAN function that can support various network adapters.
Installation platform for the LAN driver is listed as follows:
3-1-4-1. Installing LAN Driver
To install the LAN Driver, follow the steps below:
1. Connect the USB DVD-ROM device to PA-6225 and insert the driver disk.
2. Open the “LAN” folder where the LAN driver is located (depending on your OS
platform).
3. Click Setup.exe file for driver installation.
4. Follow the on-screen instructions to complete the installation.
5. Once the installation is completed, shut down the system and restart PA-6225 for
the changes to take effect.
For more details on the installation procedure, refer to the Readme.txt file that
can be found on the LAN Driver Utility.
To Next Page
Loading...
Need help?
General