EasyManuals Logo

Protek 3201 User Manual

Default Icon
66 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #26 background imageLoading...
Page #26 background image
7. Recorder function
The 3201 may be used to display and record (store in memory) trends and variations of a
Signal level as a continuous pattern of bar graphs. This feature is convent if the amplitude
Variations of a signal level under test need to be monitored over a period of time.
To set the Recorder mode use the following procedure:
[1]
(Select the Scan menu) (select Manual or search scan)
[2]
(Select the function menu) (Select spectrum or bar graph display)
[3] Input from the keyboard the frequency to be measured. If using the Manual scan mode set
the center frequency of if using the search scan input the start frequency.
[4] Set the step frequency to 0㎑. This may be accomplished as follows:
Select the step frequency menu by pressing the key.
Then press the following key sequence:
[5] Start the scan by pressing the key.
The scan will start from the left side of the LCD at a rate of 80mS/CH or 12.5Ch/Sec.
This is 3.2sec/Div. In the 80Bar graph display the scan
speed is 6.4Channels per second or 1.6 sec per division.
[6] The displays and settings may be stored in the data and setup memories
MENU ENTER ENTER
MENU ENTER ENTER
F2
0 0
CLR/.
ENTER
F1
21
21

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Protek 3201 and is the answer not in the manual?

Protek 3201 Specifications

General IconGeneral
BrandProtek
Model3201
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals