8 Test set menu
The test set menu contains the following utilities:
TEST MODE
OFF
TEST 1
TEST 2
CALIBRATE
ALL RESET
ALL CLEAR
TEST MODE
OFF
TEST 1
TEST 2
CALIBRATE
ALL RESET
ALL CLEAR
The signal level value displayed on the LCD includes the Calibration
correction factor. For normal operation this mode should be selected
The LCD displays the output from the A/D converter. Users should
avoid selecting this.
Same as Test 1.
This utility is used for internal calibration of the 3201. This utility
compares the input signal level and the level detector output and
creates a correction factor which is written in to a non volatile
memory. Users should avoid selecting this.
Initializes all settings and memory data. This utility is normally used
after replacing the internal Lithium battery.
Clears the Setup, Data and Channel edit memories and returns them
to their default state.
Caution:
Improper selection and operation of CALIBRATE and ALL CLEAR in this menu may result in
the loss of all previously stored data and setups and the deletion of internal calibration data.
9 SCRB Menu
Thie menu is optional and is reserved for future use.
47
47
To Next Page
Loading...
Need help?
General
