Protimeter MMS3 User Manual

The Condensator Mode enables the user to assess the
risk of condensation occurring on surfaces or to confirm
whether or not condensation is present on a surface.
The MMS3 can be used as a Condensator using two
modes:
MMS3 Instruction Manual
INS9800
11
4.5 Condensator mode
4.5a Surface Temperature probe (contact based)-
selection and use
Navigate to SELECT MODE -> SURFACE
TEMPERATURE PROBE and press to select the
Surface Temperature Probe mode.
SELECT MODE
78%
17 FEB 21
09:58
PIN MOISTURE METER
PINLESS MOISTURE METER
HYGROMETER
PSYCHROMETRICS
SURFACE TEMP PROBE
SETTINGS
In this mode, the MMS3 measures the surface
temperature using an external Surface Temperature
probe inserted into the socket and making contact with
the surface to be assessed. In addition to the Surface
Temperature probe, connect a Humidity probe for the
MMS3 to show the Condensation status.
TDIFF is a useful function when investigating
condensation, as it tells the user how many degrees a
surface temperature is above or below the prevailing
dew point temperature.
4.5b Surface Temperature IR (non-contact based)-
selection and use
In this mode, the MMS3 measures surface temperature
using IR technology. Connect a humidity probe into the
corresponding socket.
Hold the button to enable the IR Thermometer. Release
the button and press it again within 1 second to enable
the LASER pointer. The LASER pointer will indicate the
area on the surface where the measurement is being
taken.
QUIKSTICK SNO: 000004B06194
SURFACE TEMP PROBE
78%
17 FEB 21
09:58
SURF TEMP
SURF T.DIFF
32.4
11.3 C
10.0 C
AIR DP
C

Protimeter MMS3 Specifications

General

Brand	Protimeter
Model	MMS3
Category	Measuring Instruments
Language	English