• Use only laser pointers meeting the following
criteria:
o Labelled with FDA certification stating
“DANGER: Laser Radiation” for Class 3R
lasers or “CAUTION: Laser Radiation” for
Class 2 lasers.
o Classified as Class 2 or 3R according to
the label. Do not use Class 3b or Class 4
products.
o Operates at a wavelength between 630
nm and 680 nm.
o Has a maximum output less than 5 mW,
the lower the better.
3. Product Components and Accessories
The MMS3 instrument measures the different
parameters in the buildings: room temperature, room
humidity, building material moisture, surface moisture
and surface temperature (contact and non-contact
method). To measure all the above-mentioned
parameters, MMS3 uses different sensors, along with a
variety of accessories for convenient measurements.
The following external connections are found on the
instrument (see the figure below)
Probe socket:- This edge connection socket is for use
with a Hygrostick, Quikstick or Short Quikstick probe.
Pin moisture probe:- This jack connection socket is for
use with a moisture probe, Deep wall probes or a
Hammer electrode.
Surface temp probe:- This jack connection socket is for
use with the direct contact surface temperature sensor.
To Next Page
Loading...
Need help?
General
