Protimeter MMS3 - Surface Temperature IR (Non-Contact) Use; Data Logging: Manual and Continuous

T.DIFF (ºC)
Condensation status
Background
≤0
Condensation
Red
>0 but ≤3
Risk of condensation
Yellow
>3
No Condensation
Green
4.6 Logging – selection and use
The MMS3 supports both continuous and manual
logging.
4.6a Manual Logging
If is pressed in any of the measurement screens, the
data and Timestamp at that instant will be logged and a
RECORD SAVED message will be displayed on the
bottom bar.
4.6b Continuous Logging
Continuous logging is used to sample and store data
continuously. Continuous logging is enabled either by
setting logging parameters through the Keypad or
through a PC using MMS3 Logging Software or with the
Protimeter App after connecting through BLE refer “Set
Logging Parameters”. After the logging parameters are
saved, logging starts after the START AFTER minutes
have elapsed. The logging icon is displayed on
the top right of the screen while logging is active.
When logging is in progress, an option to stop logging is
provided under the SETTINGS menu. Logging can be
stopped either by selecting SELECT MODE ->
MMS3 Instruction Manual
MMS3 Instruction Manual
INS9800
12