Page 14
Preparat
PreparatPreparat
Preparation for Operation
ion for Operationion for Operation
ion for Operation
Before switching on, check the following:
The blackbox is mounted correctly and is in a ‘safe’ area.
The power supply is correctly installed.
The voltage selector switch is in the correct position.
The relays are connected correctly.
Main
MainMain
Maintenance
tenancetenance
tenance
There are no user serviceable parts inside your blackbox, except the mains
power fuse. If you experience any problems with the unit, then please
contact Pulsar Process Measurement for advice.
To clean the equipment, wipe with a damp cloth. Do not use any solvents on
the enclosure.
Important Information
The unique DATEM software comes into operation as soon as power is
applied, and is designed to monitor a moving level or target with the
transducer in a fixed position.
If, after any period of use, it should become necessary to move the
transducer, for any reason, from its original operating position, switch off
the blackbox, before proceeding, to prevent any undesirable updates to the
DATEM trace. If after moving the transducer the reading is not as expected
please refer to Chapter 6 Troubleshooting .
To Next Page
Loading...