Pulsar Blackbox User Manual

Page 58
Date & Time
P931 Date
This parameter shows the current date, in the format as set by P933 (Date
Format), and can be reset if required.
P932 Time
This parameter shows the current time and can be reset if required, in the
format HH: MM (24-hour format). This is set initially at the factory for UK
time.
P933 Date Format
This parameter allows you to alter the format that the date is displayed to
your choice of DD: MM: YY, MM: DD: YY or YY: MM: DD. The default
is DD: MM: YY.
Daylight Saving Time
Important Information
In order to ensure the correct operation of Daylight Saving Time P932 Time
should be checked, and adjusted if necessary, to ensure that it is set for the
current valid time.
P970 DST Enable
When Enabled (set to 1) the internal clock will be automatically adjusted to
compensate for the difference between standard time and Daylight Saving
Time. Default = 0 (Off)
P971 DST Difference
This parameter sets the time difference between standard time and Daylight
Saving Time. The time difference is entered in HH:MM. Default = 01:00
P972 DST Start Time
This parameter is used to set the time of day at which Daylight Saving
Time will start, the time is entered in the format HH: MM (24-hour
format). Default = 02:00

Pulsar Blackbox Specifications

General

Brand	Pulsar
Model	Blackbox
Category	Control Systems
Language	English