Pulsar Blackbox User Manual

Page 54
Compensation Parameters
Compensation ParametersCompensation Parameters
Compensation Parameters
Offset
P851 Measurement Offset
The value of this parameter is added to the measured distance, in
Measurement Units (P104).
This Offset will be added to the level, as derived from the transducer, and
will affect everything including the reading on the display, when connected
to the PC Handheld Communicator or the optional Handheld
Communicator, relay setpoints and the output.
Temperature
P852 Temperature Source
This parameter determines the source of the temperature measurement. By
default it is set to automatic (P852=1), which will automatically detect if a
temperature sensor is available from the transducer. If for any reason, no
temperature input is received, then the Fixed Temp value is used, as set by
P854.
The temperature source can be specifically set as follows:
Option Description
1 = Automatic (Default)
Will automatically select transducer
temperature sensor, if available, or fixed
temperature (P854) if no temperature
sensor found.
2 = Fixed Always uses fixed temperature (P854)
P854 Fixed Temperature
This parameter sets the temperature, in degrees centigrade to be used if
P852 (Temperature Source) =2. Default = 20
o
C

Pulsar Blackbox Specifications

General

Brand	Pulsar
Model	Blackbox
Category	Control Systems
Language	English