Page 63
Hardware
P992 Output Test
This parameter will allow you to force a specified current on to the output to
test any equipment that it is connected to. The figure you enter will be
generated by the output.
P993 Relay Test
Press a numeric key corresponding to the number of the relay you wish to
test, and the relay will change state each time the key is pressed. If you press
any other key, other than a valid relay number, then the test will end.
P994 Transducer Test
Press any key on the keypad, other than 0, and the transducer will
continually fire for 5 seconds, pressing 0 will terminate the test.
To Next Page
Loading...
Need help?
General