Pulsar DFM 6.1 - EU Declaration of Conformity

DFM 6.1 INSTRUCTION MANUAL
4
Available in Adobe Acrobat pdf format
EU DECLARATION OF CONFORMITY
EU Declaration of Conformity – Pulsar Measurement DFM 6.1 Transit-Time Flow Meter
This declaration of conformity is issues under the sole responsibility of the manufacturer.
Relevant Directive(s) 2014/30/EU – EMC directive and its amending directives
2014/35/EU – Low Voltage directive and its amending directives
2014/34/EU – ATEX directive and its amending directives
2011/65/EU – RoHS directive and its amending directives
Manufacturer’s name Pulsar Measurement
Manufacturer’s address 16456 Sixsmith Drive
Long Sault,
ON K0C 1P0
Canada
Apparatus Doppler flow meter including wall-mount electronics, transducer
cables, and transducer
Models DFM 6.1 with SE4-A transducers (ATEX where approved)
Type of equipment Measurement and process control
Standards applied EN 61326-1:2013 EMC, equipment class industrial
EN 61010-1:2010+A1:2019 Safety requirements for electrical equipment
for measurement, control, and laboratory use
EN IEC 60079-0:2018 ATEX general requirements
EN 60079-11:2021 ATEX intrinsic safety (Ex ia)
Notified body CSA Group Netherlands B.V. #2813
Role Certifier of ATEX type examination
CSANe 22ATEX1057X
I declare that the apparatus named above has been tested and complies with the relevant sections of the above
referenced standards & directives.
Signed: Date: November 16, 2022
Rev. 1.0
Name & function Ken Elander, Sr Product
Manager
Pulsar Measurement