DFM 6.1 INSTRUCTION MANUAL
22
SPECIAL FUNCTIONS
Language
Select English, French or Spanish
Analog Out
Select 4-20mA or 0-5V mode for the analog output.
Backlight
Select High, Medium or Low for continuous
backlight.
Select Key Hi/Lo for high backlight for 1 minute
after a keypress and then Lo backlight until a key is
pressed again.
Select Key High, Med or Low for backlight for 1
minute after a keypress and then backlight off until a
key is pressed again.
Reset Totalizer
Press and select Yes to erase and restart the
totalizer at zero.
Neg. Totals
Select Yes to have reverse flow readings deducted
from the totalizer. Select No to totalize forward flow
only and ignore reverse flow
Rev. Flo
Select On to enable flow direction measurement.
Select Off to disable flow direction measurement.
Select Invert to invert the sense of the flow
measurement.
Capture Par
This function captures the programming parameters
in the meter. Select Yes, wait for Insrt USB to appear,
then insert a USB drive into the USB port to transfer
the parameters. After Saving flashes, Done will appear
on the screen, meaning it is safe to remove the USB.
- - Sp e c i a l Fu n c t i o n s -
L a n g u a g e En g l i s h
An a l o g Ou t 4 - 2 0 mA
Ba c k l i g h t Hi g h
Re s e t T o t a l i z e r NO
Ne g . T o t a l s No
Re v . F l o w Of f
Ca p t u r e Pa r No
Ca p t u r e WF No
Re s t o r e De f a u l t s No
Ne w Pa s s wo r d 0 0 0 0
To Next Page
Loading...
