23.07.2019
Punkt. MP02 Mobile Phone - Instruction manual
Switching on and off
18
Switching on
• To switch the MP02 on, press and hold
the On/Off button on the top of the
phone.
• If the phone has been set to require a
passcode, enter it when requested and
press the key. More information
about passcodes can be found on p 20.
• If the SIM card has been set to require a
passcode, this will be requested next.
More information about the SIM
passcode (PIN) can be found on p 20.
Switching on for the first time
When an MP02 is switched on for the first
time (or after a reset), it will prompt the
user to choose a language, choose a clock
format (12hr/24hr) and enter the current
time and date, to ensure that text messages
are given a correct date stamp from the
outset.
The Back key can be used to return to a
previous stage. If the screen goes black,
press any key or button to reactivate it. The
setting-up process can be cancelled by
switching the MP02 off.
• Select a language by using the Up and
Down arrows to scroll through the list.
When the desired language is
highlighted, press to enter.
• Select the clock format by using the Up
and Down arrows again to highlight the
desired format, and then press to
enter.
• Current time: enter the hours, either
with the Up and Down arrows or the
number keys. When the correct value is
shown, press to enter. Repeat for
the minutes value.
• If 12-hour clock format has been
selected, use the Up and Down arrows
to specify AM or PM for the current
time. When the correct option is
shown, press to enter.
• Repeat this three times to set the
current date. (Note whether it is in
little-endian or middle-endian format.)
Switching off
To switch off, press and hold the On/Off
button, and then select Yes when
prompted.
To Next Page
Loading...
