Pyronix Matrix 832 Programming Manual

Matrix 424/832/832+ LCD Programming Manual
RINS916-6 Page 53
DESCRIPTION
 / 
MAIN ENTRY

ADDITIONAL DATA
Jamming fault restore
TIME AND DATE
►JAMMING CLEAR
EXPANDER
►01-02
Detector signal restore
TIME AND DATE
►SIGNAL OK
ZONE NAME
►01-32
Detector signal restore
TIME AND DATE
►SIGNAL FOUND
ZONE NAME
►01-32
Remote device has been found on bus (restore)
TIME AND DATE
►RESTORE ►DEVICE FAIL
Successful transmission to central station
(restore)
TIME AND DATE
►RESTORE ►FAIL TO REPORT
SYSTEM EVENTS
Engineer mode exited
TIME AND DATE
►ENGINEER END ►
Engineer mode entered
TIME AND DATE
►ENGINEER START ►
Walk test mode entered
TIME AND DATE
►WALK TEST ENTER ►
Walk test mode exited
TIME AND DATE
►WALK TEST EXIT ►
NVM reset to factory defaults
TIME AND DATE
►NVM RESET ►
Time and date changed by user,
number signifies code used
TIME AND DATE
►TIME+DATE
USER NAME
►01-32
Time and date changed by engineer
TIME AND DATE
►TIME+DATE
USER NAME
►01-32
Remote device lost on bus, number refers to
type/ID
TIME AND DATE
►DEVICE LOST ►01-82
Remote device found on bus, number refers to
type/ID
TIME AND DATE
►DEVICE FOUND ►01-82
UP/DOWNLOADING EVENTS
Panel answered the telephone
TIME AND DATE
►PANEL ANS TEL. ►
Panel hung up the telephone line
TIME AND DATE
►PANEL HUNG TEL. ►
Full data upload to panel
TIME AND DATE
►FULL UPLOAD ►
Full data download from panel
TIME AND DATE
►FULL DOWNLOAD ►
Partial data upload to panel
TIME AND DATE
►PARTIAL UPLOAD ►
Upload data to panel complete
TIME AND DATE
►UPLOAD OMPLETE ►
Download data from panel complete
TIME AND DATE
►DOWNLD OMPLETE ►

Pyronix Matrix 832 Specifications

General

Brand	Pyronix
Model	Matrix 832
Category	Control Panel
Language	English