GEM5000 Gas Analyzer
Page 76 of 102
Note: When using the Creating a new project from the data in the instrument option,
only IDs NOT associated with other projects will be created into the new project.
Creating a Device ID that does not measure flow Example- Probe or Sample Port
If there is no flow device you can choose the “No Flow (GA Mode)” option. Alternatively, you
can also choose User Input. When choosing the User Input option you will need to enter the
appropriate pipe inside diameter. A pump run-time must be specified in with either type of
flow device.
Figure 5—Probe Definition using "No Flow" option
Figure 6—Probe Definition using "User Input"
10.7.6 Creating Site Questions
Site questions are setup in the same manner as ID questions however unlike ID questions,
the answers for Site questions will apply to all subsequent readings until the site question is
updated. A total of 5 site questions can be sent to your instrument. These must be updated
each time you use the GEM. This is done by going to the Menu selection on the instrument
and choosing [Update Site Data]
The options for questions are Alphanumeric – Numeric – Multiple or Single comment
selection.
To Next Page
Loading...