QED LANDTEC GEM5000 - Creating IDs

GEM5000 Gas Analyzer
Page 71 of 102
Typical Comments Might Include
Valve Fully Open
Valve Partially Open
Valve Closed
Air Leak in Wellhead
Water Blockage in Header
Surging at well
Sample Port Needs Replacement
More Vacuum Needed
5 Day Recheck
10.7.3 Creating ID’s
There are several ways to input IDs to the Project. The following describes each process:
Creating new IDs with LSGAM
To create a new ID using the LANDTEC System Gas Analyzer Manager, Right Click on the left
ID pane beneath your active project and select the Add New ID option.
The Add New ID form will be displayed. From the ID Information tab of this form, entry of
the following is available:
Note: LAT & LONG will only be
available on GEMs with the NAV
option