90 QXS G2 Hardware Installation and Maintenance Guide
5 Click on “Network” to set up the IP addresses.
You can change addressing parameters for the network port in each controller module.
• You can set static IP values or use DHCP.
• When setting static IP values, you can use either IPv4 or IPv6 format.
In DHCP mode, the system obtains values for the network port IP address, subnet mask, and gateway
from a DHCP server if one is available.
• If a DHCP server is unavailable, current addressing is unchanged.
• You must have some means of determining what addresses have been assigned, such as the list of
bindings on the DHCP server.
To Next Page
Loading...
