Section V - Operating Instructions
During operation
NOTICE!
Keep the panels closed during operation
WARNING!
When the motors are stopped and LED (7) (automatic operation) is alight, the motors
may start automatically.
CAUTION!
When the automatic operation LED (7) is lit, the regulator is automatically controlling
the vacuum pump, i.e. loading, purging, stopping of the motors and restarting!
Regularly check the oil level during operation.
A few minutes after stopping, the oil level should reach the top of the oil sight glass (GI).
If the oil level is too low, wait until the vacuum pump has vented. Push the emergency
stop button (15) to avoid the vacuum pump to start unexpectedly. Next, close the inlet
isolation valve (IV).
Remove the oil ller plug (FC) and add oil until the level reaches the top of the oil sight
glass. Fit and tighten the plug (FC).
On vacuum pump with an Airlogic Graphic controller, unlock the emergency stop button
(15), select the STOP icon on the display and press reset before restarting.
Quincy Vacuum Pump-QSV Series 73
To Next Page
Loading...
Need help?
General
