Section VI - Maintenance
Air filter
Procedure
1. Stop the vacuum pump. Switch off the voltage.
2. Vent the vacuum pump by opening the plug (Ip) on the lit of the air inlet lter.
3. Remove the cover of the air lter (AF and GBF). Remove the lter element.
4. Fit the new element and the cover.
5. Reset the air filter service warning.
For vacuum pumps equipped with an Airlogic Graphic regulator, see section
Service menu.
WARNING!
When placing the air filter element, verify that the seal is present and in good
condition.
80 Quincy Vacuum Pump-QSV Series