Tach Pulse per Two Revolutions of the Engine
Set the number of pulses from the tachometer signal for two revolutions. The correct setting would
typically match the number of engine cylinders. For example, a V-8 would set at 08.
The key commands are as follows.
3) Increase pulse count by 1: Short right press - At 20 returns to 0
4) Decrease pulse count by 1: Medium right press - At 0 returns to 20
Short left press: Accept selection and go to next setup parameter
Long left press: Save programming and Exit Setup
Engine RPM Source
The dash can use the input from the PWR/TACH port on the G2X or from the EFI module if installed.
This rpm is then used for display, shift light, gear ratio, etc. The user is prompted to choose either yes or
no to EFI rpm input. No, will instruct system to utilize the PWR/TACH port on the G2X.
1) Y or n: Short right press or Medium Right Press - Toggles between Y and n
Short left press: Accept selection and go to next setup parameter
Long left press: Save programming and Exit Setup
16
To Next Page
