1
st
Edition 4-3
Development System
The PowerPact6 family supports the cross-development method of application development, as shown in
the diagram below.
$ Note: IP addresses shown are for illustration purposes only.
This allows development system tools to run on a host computer (PC or UNIX). The development
environment interacts with the target (the PowerPact6 system) via a network. Direct interaction with
PowerPact6 embedded software is via serial links to a suitable terminal or terminal emulator.
All system interconnections should be made using suitable standard or Radstone specific cables.
Connections shown indicate possible options, some of which may not be suitable or possible on all
systems.
The system shown is the minimum required for checking PowerPact6 operation and for carrying out
software development. For further descriptions of system components and other concepts refer to the
relevant documentation.
Recommended minimum development system specification is as follows:
• A 400 MHz+ PC with 64 MBytes of RAM running Microsoft Windows NT4/2000 or an
UltraSPARC machine running Solaris 2.6 or later and XWindows
• 750 MBytes of free hard disk drive space (Tornado 2), 1 Gbyte free (X11)
• A CD-ROM drive
• Ethernet interface
• 2 free RS232 serial ports
• Suitable monitor, keyboard and mouse
To Next Page
Loading...