Troubleshooting
ENG
ESP-Me Controller
35
FCC Part 15
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in
a residential installation.
This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If the equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
• Changes or modifications not expressly approved by Rain Bird Corpora-
tion could void the user’s authority to operate the equipment.
• This product was FCC certified under test conditions that included
the use of shielded I/O cables and connectors between system com-
ponents. To bin in compliance with FCC regulations, the user must use
shielded cables and connectors and install them properly.
• This class B digital apparatus meets all requirements of the Canadian
Interference Causing Equipment Regulations.
Cet appareil Numérique de la classe B respecte toutes les exigences du
Règlement sur le matériel brouilleur du Canada
Safety Information
CAUTION: This appliance is not intended for use by persons (includ-
ing children) with reduced physical, sensory or mental capacity,
or lack of experience and knowledge unless they have been given
supervision or instruction concerning use of the appliance by a per-
son responsible for their safety. Children should be supervised to
ensure that they do not play with the appliance.
WARNING: Special precautions must be taken when valve
wires (also known as station or solenoid wires) are located
adjacent to, or share a conduit with other wires, such as those
used for landscape lighting, other “low voltage” systems or
other “high voltage” power.
Separate and insulate all conductors carefully, taking care not
to damage wire insulation during installation. An electrical
“short” (contact) between the valve wires and another power
source can damage the controller and create a re hazard.
WARNING: All electrical connections and wiring runs must
comply with local building codes. Some local codes require
that only a licensed or certied electrician can install power.
Only professional personnel should install the controller.
Check your local building codes for guidance.
NOTE: Date and time are retained by a lithium battery which
must be disposed of in accordance with local regulations.
CAUTION: Use only Rain Bird approved accessory devices. Unap-
proved devices may damage the controller and void warranty. For a
list of compatible devices go to: www.rainbird.com
To Next Page
Loading...
Need help?
General
