R&S 4200 Series - Page 62

R&S XU 4200 Configuring with the R&S ZS 4200
6166.5368.02.01 3.10
Parameters Value range Default value Properties
S/N RSSI Logical Operation AND/OR OR C
TX AM Modulation Depth 30 to 90 % 85 % A/C
TX Audio ALC Disabled/Enabled Enabled C
RX Audio AGC Disabled/Enabled Disabled C
PTT Timeout 3 to 300 s,
0 (disabled)
30 s C
PTT Input Configuration Type I / Type II /
R&S Standard
R&S Standard C
True SideTone Transceiver Disabled/Enabled Enabled C
5-Carrier Offset Disabled/Enabled Disabled C
Select Audio Interface Analog Audio/E1/VoIP Analog Audio C
RX Input Sensitivity Low Noise/Low Distortion Low Noise C
225.000 to 399.975 MHz for
spacing 25 kHz
312.400 MHz
8.33/12.5/25 kHz 25 kHz
–8 / –7.5 / –7.3 / –5 / –4 /
–2.5 / 0 / +2.5 / +4 / +5 /
+7.3 / +7.5 / +8 kHz
Note: Insignificant for RX
module
0 kHz
Set/Get Values for Preset
Page
AM AM
C
Installation Info Max. 20 characters No text C
Location Info 10 lines each
max. 20 characters
No text C
192.168.52.101
255.255.255.0
192.168.52.1
for RX module
IP Address
(radio in IPv4 mode)
IP Address
Netmask
Gateway
192.168.52.102
255.255.255.0
192.168.52.1
for TX module
IP Address
(radio in IPv6 mode)
IP Address/Prefix length
Gateway
fc00::1/64
::
for RX module
fc00::2/64
::
for TX module
ACL (Access Control List)
(radio in IPv4 mode)
IPv4
20 Entries
Empty C