R&S SMW200A - Page 58

Trying Out the Instrument
R&S
®
SMW200A
58Getting Started 1412.9220.02 ─ 21
To connect the instrument and the external trigger source
1. Use a suitable cable to connect the external trigger source to the USER 3
connector of the R&S SMW, see Figure 6-6.
RF
INPUT
REF OUT
(Rear Panel)
REF IN
RF A
Reference
Signal
INPUT
TRIGGER
Global Trigger 1
External Trigger Source
USER 3
Figure 6-6: Simplified representation of a test setup**
** = The figure depicts the cabling as a general principle; in a particular test setup not all
connections are required at the same time
Triggering the Instrument with an External Signal