Trying Out the Instrument
R&S
®
SMW200A
59Getting Started 1412.9220.02 ─ 21
The Figure 6-6 depicts the location of the connectors and explains the con-
nection as principle. In practice, you would rather "substitute" the analyzer by
a DUT, like a base station (BS). Other than in the example, the DUT can be
the source for the reference signal. Instead of using an external trigger
source, the DUT can also sends for example a frame trigger signal to the
R&S SMW. The R&S SMW acts still as the signal source.
2. Use suitable cables to connect the RF A/B and REF OUT connectors of the
R&S SMW to the signal analyzer or the DUT.
Upon the receiving of an external trigger event, the R&S SMW starts the sig-
nal generation and then generates a continuous signal. An "Arm" stops the
signal generation. A subsequent trigger event causes a restart of the signal
generation.
Triggering the Instrument with an External Signal
To Next Page
Loading...
