Repairs R&S ZVA
1177.5333.02 3.36 E-11
Installing the new front module controller and putting the instrument back
together
Disconnect all cables from the FMR7/x unit (2*LAN, USB, SATA), remember the position from the 2
LAN cables, they must be connected with the same connector like the FMR7/x unit
Disassemble the FMR7 or FMR9 by unscrewing (590) (see drawing 1145.1310.01).
Notice the FMR11/6 specific data e.g. partnumber, serialnumber, productindex.
Assemble the FMR11/6 with 9 screws (590) (see drawing 1145.1310.01).
Connect cables (USB, 2 *LAN, SATA data (use right SATA connector), SATA power).
Fit the instrument top cover (296) and secure it with all countersunk screws (299).
Mount the new Cover 1312.7627.00 and fasten it with the screws (700)
Reconnect cables for the DISPLAY unit, USB, two Flexible Switch Foils and the cable from Rotary
Puls-Generator
For the next steps see chapter Replacing Front Modul Controller A90
Add the Windows 7 licence sticker on the predefined position ( Drawing 1145.1310.00)
To Next Page
Loading...
