CHAPTER 2
8 CAN Sidekick Pro Injection for Case IH 3/4XXX Installation and Operation Manual
TABLE 1. Case IH Make and Model Information,
FIGURE 1. Case IH 4440
REQUIRED COMPONENTS
The following components must be installed with the Sidekick Pro:
• Raven OS Version 2.1.5.32 for the Viper 4 Console or Pro 700 Console Software Version 30.
TOOLS AND MATERIALS NEEDED
The following tools are recommended for completing the installation:
• SAE wrenches and tools
• Drill bit set and drill
• Dielectric grease (supplied)
• Cable ties (supplied)
• Tape measure
•Center punch
• 3/4” drill bit
•Welder
• Reciprocating saw with metal blade or hacksaw
• Torque wrench
•Welding clamps
• Thread sealant tape
POINT OF REFERENCE
The instructions provided in this manual assume the installer is standing behind the machine, looking toward the
machine cabin.
Make Model
Case IH 3/4XXX
To Next Page
Loading...
Need help?
General
