CHAPTER
5
Viper 4 (ROS) Initial Set-Up: Raven OS Setup 61
CHAPTER 5
VIPER 4 (ROS) INITIAL SET-UP
RAVEN OS SETUP
Once installation of the injection system has been verified, and the motor control node is recognized by the Raven
OS device, the Sidekick Pro and display device must be calibrated to provide accurate control of the injected
product. If more than one SideKick Pro is installed, the product nodes will have to be addressed in the correct
order.
NOTE: Firmware version 1.21.7 or higher is recommended for the Sidekick Pro injection node. Refer to the
Raven OS Basic Operation manual for assistance with checking or upgrading node firmware for nodes
on the Raven CANbus.
The Sidekick Pro motor control node is only capable of operating in a liquid chemical application
mode.
ROS version 2.1.5.32 or higher is required for operation.
The following settings must be calibrated or programmed to ensure proper control and operation of the Sidekick
Pro pump.
• Pump type
• Meter cal
• Valve cal (may also be referred to as Motor cal)
• Pressure transducer cal
• Section setup
• Flow to Encoder Ratio (FER) error cal
SECTION SETUP
NOTE: These settings must be programmed for each injection product or pump that will be used to control
product during field operations.
Before attempting to configure the injection pump, verify that the Raven OS device has been
detected the motor control node. Refer to the Raven OS Basic Operation Manual for additional
assistance with detecting and troubleshooting the CANbus system.
INJECTION SETTINGS, SETUP, AND DEFINITIONS
The following sections are intended to provide detailed descriptions of settings, features, and options available for
operation of Sidekick or Sidekick Pro injection systems.
To Next Page
Loading...
