CHAPTER 3
38 CAN Sidekick Pro Injection for Case IH 3/4XXX Installation and Operation Manual
FIGURE 51. Installed Calibration and Recirculation Valve Assembly
4. Use the provided gasket and clamp to attach the provided calibrator and recirculation valve assembly to the
pump outlet as shown.
NOTE: For single pump systems this valve assembly replaces the existing outlet fitting on the calibrator.
Attach the valve and fitting assembly directly to the check valve for the single pump system.
FIGURE 52. Single Pump Recirculation Valve Assembly
RINSE PLUMBING INSTALLATION
RINSE PLUMBING INSTALLATION
1. Apply the provided thread sealant to all threaded joints.
2. Locate the 1-1/4” rinse tank supply hose under the cab behind the front axle for 3XXX machines, or behind the
main solution tank for 4XXX machines.
Attach Calibration
Assembly to Pump
Outlet using Provided
M100 Gasket and M100
Clamp
Calibration and
Recirculation
Valve Assembly
Install Valve
Assembly
Remove 1/2” Hose Barb to 1/2” FNPT
Fitting and Replace with 1/2” Valve
Assembly
1/2 NPT to Hose
Barb Elbow
Thread Check Valve Into Here
To Next Page
Loading...
