CHAPTER 3
20 CAN Sidekick Pro Injection for Case IH 3/4XXX Installation and Operation Manual
3. Mount pump 1 to the pump station bracket on the side nearest to the battery box, using the closest hole
pattern next to the frame with the 5/16” - 18 x 1” bolts, 5/16” washers (two per bolt), and 5/16” nyloc nuts. Ensure
the pump does not contact the machine’s carrier product strainer.
FIGURE 19. Installed Pump
4. Mount pump 2 (optional) on the front side of the pump station bracket using 5/16” - 18 x 1” bolts, 5/16” washers
(two per bolt), and 5/16” nyloc nuts. Verify pump 2 does not contact tank support components.
FIGURE 20. Pump Station Installed
5. Install the pump shield on the pump station using 3/8” - 16 x 1-1/4” bolts and 3/8” washers.
Pump 1 Nearest
Battery Box (as
close to frame as
possible)
Optional Pump 2
In Front of Pump 1
(away from frame
to clear tank
supports)
Pump 1 Installed
Next to Battery
Box. (Ensure
pump 1 does not
contact the
strainer. Pump
should be as
close to the
frame as
possible. The
strainer may
need to be
rotated slightly.)
Pump 2
Installed on the
Opposite Side
of the Bracket.
(Ensure pump 2
does not
contact tank
support
components.)
To Next Page
Loading...
