8
|
nVent.com/RAYCHEM RAYCHEM-OM-EU2032-NGCUIT3EX-EN-2203
16. The section titles in this Agreement are for convenience only.
17. You agree that the terms and conditions of this Agreement shall survive any termination of this Agreement and your
rights to use the Software.
Should you have any questions concerning this Agreement, or if you desire to contact nVent for any reason, please write to:
nVent
307 Constitution Drive
Menlo Park, CA 94025-1164
U.S.A.
The performance, reliability and safety of your heat-tracing system depend on proper design, selection, and installation. The NGC-
UIT3-EX Software will help you configure and monitor a system that meets your requirements, but it is only a tool. It assumes
that your input is accurate, that you are familiar with heat-tracing system design and configuration, and that you will ensure that
all components of the heat-tracing system are installed, maintained and used as intended. The configuration of the NGC-UIT3-EX
Software should be reviewed by a knowledgeable engineer to ensure it is appropriate for your application. Additional information
relating to safety, design, and installation is contained in Design Guides, Installation Manuals, Data Sheets, and other literature
available from nVent. Be sure to consult these documents as needed.
There are important safety warnings which are shipped with nVent products and that are also printed in the Elexant 5010i, NGC-20
Installation Manual (RAYCHEM-IM-INSTALL130-NGC20CLE-ML) and NGC-30 Installation Manual. Be sure to read and follow these
safety warnings to reduce the risk of fire, shock, or personal injury. If you have any questions, contact your local representative or
contact nVent directly.
Under certain conditions, the NGC-30 program will alert the user with a warning or an error message. These are typically either
because the program cannot find an acceptable answer based on user input, or because the user may need to take some additional
action to ensure the design requirements are completely met. These warnings and error messages are detailed on page 52.
For technical support, contact your local representative, or contact nVent directly:
nVent
7433 Harwin Drive
Houston, TX 77036
USA
Tel: 800-545-6258
Tel: 650-216-1526 (outside U.S.)
email: technicalsupport@nVentthermal.com
Navigation
The top row of the window contains the main menu buttons, and the bottom row contains subsets of those main menu buttons.
When asked to navigate between windows in this manual, simply press a combination of a Main Menu | Submenu buttons.
For example in Step 1, the System | Misc window must be accessed. To perform this action, press the System button on the top row.
On the bottom row, press the Misc button.
On Setup and Status windows, a Status legend displays. This information shows what Device address and Relay address have been
assigned to a particular Circuit.
To Next Page
Loading...
Need help?
General
