2 E-Series Networked Display Reference Manual
1.2 What can the E-Series Display do?
With the appropriate equipment connected to your system and the necessary data
available, your E-Series display combines the following applications which are used to:
Chart (Chapter 4)
You will need a chart card, and position/heading data, for the chart application to be
fully functional.
3-D Chart (Chapter 5)
You will need a chart card and accurate heading and position data for your 3D chart
application to be fully functional.
Fishfinder (Chapter 6)
You will need position data, in addition to a DSM300, for your fishfinder to be fully
functional.
0.5nm North-Up (Relative Motion) Local
D7363_2
Locate where you are.
Interpret your surroundings.
Monitor where you are going.
Record where you have been.
Navigate to a specified position (waypoint).
Build and navigate routes.
View details of nearby features & services.
View details of boats equipped with AIS.
Distinguish between fixed and moving objects.
Measure distances and bearings.
D8702_1
Display a 3D view of land, sea & features.
Locate where you are.
Interpret your surroundings.
Monitor where you are going.
Go to an existing waypoint.
Navigate a route.
Synchronize with the 2D chart.
Identify fishing spots
Draft
D7377-1
Build a picture of what is below your vessel.
Locate & distinguish underwater objects & targets.
Distinguish the seabed and its texture.
Obtain information about water depth, temperature.
Mark a point of interest, fishing spot etc.
Determine depths and distances of targets.
TRANSDUCER
SETTINGS…
ZOOM… BOTTOM LOCK… A-SCOPE… PRESENTATION…
200kHz: Auto Range: Auto
To Next Page
Loading...
