Chapter 1: Overview 5
1.3 The Simulator
The E-Series Display includes a simulator
mode, which allows you to practice operating
your display without data from a GPS antenna, radar scanner. fishfinder or an AIS
receiver. The simulator mode is switched on/off in the System Setup Menu (see
page 262
). Once enabled, you can use the simulator:
• Before installation - Simply connect the display to a 12V DC power supply,
fused at 1 amp by attaching the red core from the power lead to positive (+) and
the black core to negative (-).
• After installation - Whilst in a marina or at anchor.
Please note that system settings made whilst in simulator mode, are not transmitted
via SeaTalk to other equipment.
Important: Incoming AIS safety messages cannot be displayed while the simulator is
switched on.
To Next Page
Loading...
