98 ST4000 Plus Wheel & Tiller Autopilots Owner’s Handbook
The aut opi lot w ill not “ t al k” t o ot her SeaTalk i nst rument s
ïCabling problem ñ make sure all the cables are connected properly.
Posit i on i nf or mat i on not r eceived
ïNavigator not transmitting the correct position data.
The aut opi lot w ill not aut o advance t o t he next w aypoint
ïNo bearing to waypoint information received from the navigator.
A series of rot at ing dashes are displayed on screen
ïCompass deviation correction or dockside rudder calibration is
running.
The displ ay show s a series of st at ionar y dashes
ïData is not being received ñ check the cabling.
The di spl ay show s NO DATA
ïThe signals received from the navigator are too weak ñ refer to the
navigator handbook for further action.
ïWind trim data is not available ñ check the connection to the wind
transducer.
To Next Page
Loading...
