70 ST4000 Plus Wheel & Tiller Autopilots Owner’s Handbook
Tiller bracket s
Where the height of the tiller above or below the cockpit seat or
mounting plane is such that standard mounting is not practical, a range
of tiller brackets allow the tiller pin offset to be varied.
1. Position the tiller bracket on the centre line (upper/lower) of the
tiller and establish control dimensions A and B.
2. Mark the position of the centres of the two fixing bolt holes.
3. Drill two 6†mm (0.25†in) diameter clearance holes through the
centre line of the tiller.
4. Install the tiller bracket using two 6†mm (1/4†in) diameter bolts,
nuts and washers.
5. Bond the fixing bolts in place with epoxy adhesive and fully
tighten the nuts.
Dimension D Dimension E Part No
(Below Tiller) (Above Tiller)
25 mm (1.00 in) 51 mm (2.00 in) D009
51 mm (2.00 in) 76 mm (3.00 in) D010
76 mm (3.00 in) 102 mm (4.00 in) D011
102 mm (4.00 in) 127 mm (5.00 in) D012
127 mm (5.00 in) 152 mm (6.00 in) D013
To Next Page
Loading...
