Chap t e r 6 : I ns t al l at i on
65
The mounting procedure is exactly the same as the pedestal bracket.
Note: A clearance hole for the motor/gearbox tube may be needed.
D1 6 0
Ca b l i n g
The drive actuator is supplied with 4.5†m (15†ft) of two core cable.
1. Route the cable through the pedestal (or guard rail) and back to the
control head.
On pedestals, route the cable down the cable duct (there is usually
one fitted for the compass light) to make sure the cable cannot foul
the steering mechanism.
To Next Page
Loading...
